Avian Motors Electric Vehicle Prototype

So now I am getting pretty happy with the ghost. I changed the wheels, changed the trim to aluminum, and added the side trim. I am sure I will make a few more tweaks here and there, but this is pretty much complete.  The Ghost with the new trim. Also went back to the mag wheels. The door is on the right side so you can enter onto the sidewalk side instead of the traffic side. Street legal and insured! I might make a few changes over the winter to the drive train to clean up the chain noise. But that it pretty much it. I think I am coming to an end of this blog. But there are two more posts I have planned. One will be the lessons learned; both in design and in project management. The last one will likely be in the same vain, but what the next version might look like. Assuming there is a next version.

Finally done after all these years! The retro look is in: Front (above), Side (below) I had mixed feeling about being done. The more I thought about it, the more I knew that something was wrong. What really bothered me was that I could not quite put my finger on the problem. It is the side that really seems off. I just do not like the vertical line between the aluminum front and the wood side panels. So I pulled a photo into "paint" and tried some ideas. It looks like I can fix it up fairly easily. Idea (so far): Just that little piece, to blend the front to the side, seems to do wonders. In additon, there is a black plastic cap between the interior and exterior that I will change to aluminum. With a little luck these small changes can be done in a reasonable amount of time. If history is any lesson it will be a while :-(  ! If you have any ideas, please download a photo and try it out in your favorit photo editor. I am open to suggestions!